Climate/bosch_bth-ra_control.yaml

@@ -237,6 +237,7 @@ variables:
     {% endif %}
   
   # Temperatur-Berechnungen
+  # Priorität: 1. Alarm armed_away → away_temperature, 2. Aktiver Zeitplan → scheduled_temperature, 3. Fallback → away_temperature
   target_temperature: >
     {% if alarm_control_panel and is_state(alarm_control_panel, 'armed_away') %}
       {{ away_temperature }}
@@ -245,6 +246,7 @@ variables:
     {% else %}
       {{ away_temperature }}
     {% endif %}
+  # Begrenzt target_temperature auf den Bereich [min_temperature, max_temperature] (Clamping)
   safe_temperature: >
     {{ [min_temperature, [max_temperature, target_temperature | float(18)] | min] | max }}
   
@@ -253,6 +255,7 @@ variables:
     {{ safe_temperature is not none and safe_temperature | is_number }}
   is_temperature_change_needed: >
     {{ (safe_temperature | float(0) - state_attr(trv, 'temperature') | float(0)) | abs >= temperature_change_tolerance }}
+  # Synchronisation nötig wenn: 1) Differenz > Schwelle, 2) Sensor kreuzt Soll-Temp von unten, 3) Sensor kreuzt Soll-Temp von oben
   is_sensor_sync_needed: >
     {% set new_sensor_temp = states(temperature_sensor) | float(0) %}
     {% set target_temp = state_attr(trv, 'temperature') | float(0) %}
@@ -277,6 +280,7 @@ variables:
     {{ (state_attr(trv, 'temperature') | float(0) - safe_temperature | float(0)) | abs >= temperature_change_tolerance }}
   
   # Override Reset Berechnungen
+  # Konvertiert duration-Dictionary {hours, minutes, seconds} in Gesamtsekunden
   override_reset_duration_seconds: >
     {{ (override_reset_duration.hours | default(0) | int) * 3600 + 
        (override_reset_duration.minutes | default(0) | int) * 60 + 
@@ -285,6 +289,7 @@ variables:
     {{ states[setpoint_change_source_entity].last_updated if setpoint_change_source_entity_valid else none }}
   is_setpoint_manual: >
     {{ setpoint_change_source_entity_valid and states(setpoint_change_source_entity) == 'manual' }}
+  # Early exits: 1) Keine Änderung/Timeout=0 → false, 2) Nicht manuell → false, 3) Berechne Zeitdifferenz
   override_duration_exceeded: >
     {% if override_last_change == none or override_reset_duration_seconds == 0 %}
       false